Raypak B6000 Manuel d'utilisateur télécharger pdf (Page 24)

Boiler Status

Operating status of boiler *Boiler

Ok or Fault Indicator Pushing "+" or "-" buttons will show

status of other boiler(s) in system

READOUT

Readout

OK - boiler operation normal

FAULT indications: MAX TEMP - Target exceeds Max Temp -Not a fault-

THERMOSTAT - Operating aquastat - Not a fault -

LWCO - low water cutoff - when supplied

LO PRES WTR - Low pressure water - when supplied

LO PRES GAS - Low pressure gas - when supplied

HIGH PRES GAS -High pressure gas

HIGH LIMIT -

FLOW SWITCH - Flow switch

NO PILOT -

MANUAL OVERRIDE - Boiler in emergency or manual operation

• When a fault is indicated, the red light, to the right of the display, flashes and the alarm

buzzer sounds. The light continues to flash after alarm is silenced and until the fault is

corrected.

• When fault is corrected display will read "OK"

• Should communication between the system control module and the boiler monitor

module(s) be disrupted, the display will show "BOILER NOT ON-LINE".

• To display status of other boilers press the (+) or (–) buttons on multiple boiler installations.

Page 24

STATUS: Boi l e r #X

-- OK --

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 50 51

Pas de commentaire

Raypak B6000 Manuel d'utilisateur Page 24