Raypak 850 Instructions d'exploitation Page 59
- Page / 60
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
START-UP CHECKLIST FOR THE XFYRE
This start-up checklist is to be completely filled out by the service technician starting up the Raypak Boiler or Heater
for the first time. All information may be used for warranty purposes and to ensure that the installation is correct.
Additionally this form will be used to record all equipment operation functions and required settings.
GAS SUPPLY DATA CLEARANCES
Regulator Model & Size _________ / ______CFH Front Clearance _______________In.
Gas Line Size (in room) ________________In. NPT Right Side Clearance _______________In.
Length of Gas Line ________________Eq Ft Left Side Clearance _______________In.
Low Gas Pressure Setting ________________In. WC Rear Clearance _______________In.
High Gas Pressure Setting ________________In. WC Overhead Clearance _______________In.
Gas Shut-Off Valve Type ________________
( Ball, Lube cock)
ELECTRICAL
Sediment Trap ________________Y/N Voltage Supply (VAC) No Load______ Load_____
P
ort _______Std______Full Voltage -24 VAC _______________VAC
Voltage Com to Ground _______________VAC
VISUAL INSPECTION OF COMPONENTS
Verify inspection was done and condition of components are in
good working order with a “yes”
Auto High Limit Setting
Manual Reset High Limit Setting
_______________deg F
_______________deg F
Wiring Harness _________________ Y/N Operating Control Setting _______________deg F
Burner/s (flame) _________________ Y/N
Refractory (visual) _________________ Y/N Sketch plumbing on reverse side
Remote flame sense _________________ Y/N
WATER SUPPLY
Covers in place for outdoor _________________ Y/N Flow Rate in GPM or Delta T _______________If Avail
Measure flow rate at full fire
VENTING
Pump Off Delay setting _______________Minutes
Vent Size: _____________ Stack Height:_______ Low Water Cutoff _______________Test
Category: _________ sketch vent on reverse side *** Number of Tanks and Size Qty____ _______Gallons
Vent Material: __________________ Plumbing Size _______________
Vent Termination Type: __________________ Pump Size: _________ (boiler) Pump HP: ______
Combustion Air Openings: Low __________ in2 Impeller trim____________ Pump Model___________
Ventilation air High __________ in2 Louvers __________________ Screens________________
EMISSIONS SETTINGS AND TEST INFORMATION Nominal Factory Recommended Settings
Air Intake Pressure _________________In. WC See manual or card tag
Supply Gas Pressure
Verify stable pressure static &
_________________In. WC
dynamic condition
See manual or card tag
Manifold Gas Pressure _________________In. WC See manual or card tag
The following measurements must be obtained with a Combustion Analyzer.
NOX _________________PPM Less than 20 PPM (If required by Certifying Agency)
CO _________________PPM Less than 150 PPM
CO2 _________________% See manual
Model Number: ______________________________ Serial Number: _______________________________
*** Note: draw venting with details, such as extractors,
barometric dampers, blast dampers or draft inducers
Site Altitude Above Sea Level __________________Ft.
Job Name _______________________________________________________________________________________
Address _________________________________________________________________________________________
Physical Location of Boiler: Indoors______; Outdoors______; Ground Level______; Roof______; Below Grade______
Mechanical Contractor / Installer _______________________________________________________________________
Date and Time of Start-up _____________Print Name and Signature of Start-up Technician_________________________
Information must be faxed to: (805) 278-5496 in order to ensure warranty consideration Attn: Service Manager
High Low
N/A
59
- INSTALLATION & OPERATING 1
- INSTRUCTIONS 1
- CONTENTS 3
- WARNINGS 4
- BEFORE INSTALLATION 5
- General Information 6
- Component Locations 6
- GENERAL SAFETY 7
- INSTALLATION 8
- Indoor Units 9
- Conventional Combustion Air 11
- Water Piping 12
- Hydronic Heating 13
- Feedwater Regulator 14
- Air-Separation/Expansion Tank 14
- Three-Way Valves 14
- Applications & Modes 14
- Domestic Hot Water 16
- Gas Supply 17
- Gas Supply Pressure 18
- Electrical Power Connections 19
- Check the Power Source 20
- Field Wiring Connections 21
- Cascade System Pump and 24
- Sensor Wiring 24
- Cascade Follower Pump 24
- Modbus BMS Communication 24
- Alarm Connection 25
- Vent Terminal Location 26
- Support of Vent Stack 26
- Venting Installation Tips 28
- Venting Configurations 28
- Venting (Category IV) 30
- Direct Vent—Vertical 32
- Condensate Management 33
- Controls 34
- Outdoor Installation 34
- FIXED SETTING 35
- ADJUSTABLE 35
- Flow Switch 36
- Flue Temperature Limit 36
- Low Water Cut-Off (Optional) 36
- (Optional) 36
- Operating Instructions 37
- Adjusting the XFyre Setpoint 38
- View Menu 38
- Setup Menu 38
- User Interface 38
- Table T: Adjust Menu 39
- Boiler View Menu 40
- Monitor Menu 41
- Toolbox Menu 42
- Outdoor Reset Concept 42
- Reset Ratio/Outdoor Reset 42
- Fig. 40: Reset Ratio 43
- DIAGRAM 44
- START-UP 45
- Preparation 46
- Start-Up 47
- Finishing 48
- Follow-Up 48
- Post Start-Up Check 48
- Safety Inspection 48
- TROUBLESHOOTING 49
- OPERATION 49
- XFyre Fault Text 50
- LED Error Code Listing 51
- Sensor Resistance Values 52
- MAINTENANCE 53
- Semi-Annually 54
- Annually 54
- As Required 54
- Instructions 55
- WARNING: 55
- APPENDIX 56
- LIMITED PARTS WARRANTY 58
- XFYRE – TYPE H and WH 58
- MODELS 300A-850A 58
- High Low 59
- Litho in U.S.A 60
Produits connexes et manuels pour Chauffe-eau et chaudières Raypak 850
(59 pages)
(90 pages)© 2020, manymanuals.fr. Tous droits réservés | 1.485 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels