Raypak B6000 Spécifications télécharger pdf (Page 6)

3.0

Hardware Setup

3.1 1500 Interface Card Setup

3.1.1 Connecting Power to the T-2 Card

The T-2 Card requires an external source of DC voltage. The DC source

voltage should be between 9V and 30V. The power is connected to TB1,

located near the two 9 pin serial port connections.

The connection to TB1 is as follows:

TB1-1 9-30 VDC (+)

TB1-2 Common (-)

3.1.2 Dip Switch Configuration

The T-2 card is configured primarily through two sets of dip switches.

These switches are read initially on power up only.

The function of the dip switches is as follows (a value of one (1) is

registered when the switch is in the ON position):

OFF Position: OFF Position:

ON Position: ON Position:

SW1 : Metasys Port Configuration

Switch

Position Function Positions

1 Baud Rate 3 2 1

2 Selection 000300

3 001600

0 1 0 1200

0 1 1 2400

1 0 0 4800

1019600

- *

1 1 0 19200

1 1 1 19200

4 Parity 5 4

5 Selection 0 0 None

- *

0 1 Odd

1 0 Even

1 1 Invalid

6 Not Used

SW2 : Metasys N2 Slave Address Configuration

Switch

Position Function Positions

1 Baud Rate 1 Address Bit 0 Value = 1

2 Address 2 Address Bit 1 Value = 2

- *

3 Select 3 Address Bit 2 Value = 4

4 4 Address Bit 3 Value = 8

5 5 Address Bit 4 Value = 16

6 6 Address Bit 5 Value = 32

7 7 Address Bit 6 Value = 64

8 8 Address Bit 7 Value = 128

* Factory Settings

9600, No Parity, Address Bit 1

12345678

• •••••

••

SW 1

12345678

• ••••••

•

↓

SW 2

↓

1 2 3 4 5 6 7 8 9 10 11 ... 22 23

Commentaires sur ces manuels

Pas de commentaire

Raypak B6000 Spécifications Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Chauffe-eau et chaudières Raypak B6000